I am living in Norway and there is no others to ask about this. I have looked for any talking or solution on a problem? I think I do have - VIBRATION! Sounds familiar to many I know. I do own a Excalibur and my saw is vibrating a lot. I have tried to enter the blades differently on the upper and below but it is never cutting straight up/down. And it is also not straight forward either. I have tried to adjust the screws, the screw on the rare end of the engine - left side from where you are sitting. NO luck. By putting my hand on the upper part where I enter the blade it is no vibration.
To tell the truth - I like the saw - but something is wrong. Could anyone give me some ideas by e-mailing me?
Sincerely and thanks in advance. Steinar in Norway