|
|
Reply
| | Message 21 of 29 in Discussion |
|
I've also been having problems with drilling holes in the middle of a project where the drill press can't reach. I've found a plunge router attachment for the Dremel and think maybe this is the solution to my problem. If I use a drill bit instead of a router bit and line it up properly where I need to drill my hole then I (theoretically) can just push down on it and it should drill a nice straight hole. My only question is concerning the length of the drill bit. Since drill bits are much longer than router bits I may have to shorten the length of my bits to work with the attachment but I'm thinking it's worth a try for $30.00. I'm going to Lowes this evening to pick one up and I'll let you know how/if it works. Carole |
|
|
|