|
|
 |
Reply
| | | Message 1 of 8 in Discussion |
| From:  ROBaUSA1 (Original Message) | Sent: 10/26/2007 2:45 AM |
I used a Dewalt 788 for a scroll saw demo a couple weeks ago and noticed a problem. The length between upper and lower blade holder was too long. You have to catch the blades on the very tip. These are standard blade that would normally have 1/4" to 1/2" sticking out. There were Dewalt reps on site and they had no clue how to adjust it. Is there an adjustment that will bring the blade holders closer?
Rob |
|
|
|
Free Forum Hosting
Important Announcement
Prev Message
