 |
|
Reply
| | From:  Gunrockets (Original Message) | Sent: 25/05/2003 16:39 |
| : Swifty (Original Message) | Sent: 1/12/2003 3:30 PM | | Winchester Brass, 41.0grs IMR4350, 50 gr Nosler ballistic tip Punches cloverleafs at 100 yds with my Ruger 77 MK1 Heavy Barrel Swifty | <NOBR> First </NOBR> <NOBR>Previous </NOBR> <NOBR>2-7 of 7 </NOBR> <NOBR>Next </NOBR> <NOBR>Last </NOBR> | Reply
 |  0 recommendations | Message 2 of 7 in Discussion | | | This message has been deleted by the author. | | Reply
| | | imr 4064 - 39 grains, hornady v-max ballistic tip 55 gr. moly, winchester primer | | Reply
| | | From: Woody | Sent: 3/16/2003 9:45 AM | | 38.5 gr. of IMR 4064.......52 gr. Sierra Match HP......3800fps | | Reply
| | | From: Harvey | Sent: 5/15/2003 12:55 PM | | I have to agree with you this is a very good load I have been using this load in my Ruger 220 for 25 yrs. and it is a real nail driver. I don't think that you can beat IMR 4064 when it comes to the swift. | | Reply
| | | From: dingus | Sent: 5/18/2003 2:38 AM | | I used to agree that the 4064 was the powder, but now I believe that R-15 in most accurate in the 2 swifts I deal with. For 50-55 gr bullets, about 37 grs for the 55. sneak up on that. dingus | | |
|
 First
Previous
2-3 of 3
Next
Last
|
Reply
| |
PET LOADS PAGE.......All load data should be used with caution. Always start with a reduced load first to make sure it is safe in your gun before proceeding. Since the GUN ROOM has NO control over YOUR choice of components, guns, or actual loadings, neither the GUN ROOM, the management team, nor the various firearms and components manufacturers assume any responsibility for the use of this data.
|
|
Reply
| | | From: EDip | Sent: 21/07/2003 17:28 |
For my Rem VSSF I found 43.3 grns of H414 with the Horn 55 grn V-Max to be most accurate. I tried many bullet/powder combinations. This is max for Horn manual so needed worked up to. Chrony shows velocity a little over 3800 fps. |
|
|
Recommend